Your Trusted Tucson, AZ Plumbing Experts

Low water pressure can be frustrating. It means water comes out slowly from your faucets or showerheads. Many things can cause this problem. Sometimes, it’s as simple as a clogged aerator on your faucet. This is the small screen at the end of the faucet spout. Minerals in the water can build up there and block the flow. You can often unscrew the aerator, clean it, and put it back. Another common reason is a problem with your water heater. If the water heater is old, sediment can build up inside, reducing water flow. This often shows up as low hot water pressure. Also, leaks in your pipes, even small ones, can cause a drop in pressure throughout your home because water is escaping before it reaches your fixtures. If you notice a sudden drop in pressure in all parts of your house, it might point to a larger issue with your main water line or a city water supply problem. Our experts at AllStar Plumber Tucson AZ know how to find the exact cause and fix it properly. We check all parts of your system, from the main line to each faucet, to make sure your water pressure is strong and steady.

A leaky faucet is not just annoying; it wastes a lot of water and can increase your water bill. Most leaky faucets drip because of a worn-out washer or O-ring inside the handle. These small rubber parts wear down over time. To fix it, first, turn off the water supply to that specific faucet. Look under the sink for a small valve on the water pipes. If you cannot find one, you may need to turn off the main water supply to your whole house. Next, use a screwdriver to take apart the faucet handle. You will find the washer or O-ring inside. Take it out and replace it with a new one that matches. You can buy these at any hardware store. Then, put the faucet back together. Turn the water back on slowly and check for drips. If the leak continues, or if your faucet is an older or more complex model, it might be time to call a professional. Our plumbers at AllStar Plumber Tucson AZ have the right tools and parts for all types of faucets and can stop leaks quickly, saving you water and money.

Your water heater works hard every day, and like any appliance, it can have problems. One common sign is a lack of hot water, or water that is not as hot as it used to be. This could mean the heating element is failing, or there is a problem with the thermostat. Another sign is strange noises coming from the tank, like rumbling or popping sounds. These noises often mean there is sediment buildup inside the tank. Sediment can make your water heater less efficient and shorten its life. Cloudy or rusty-colored hot water is also a red flag. This can happen if the inside of your tank is rusting. Lastly, if you see water pooling around the base of your water heater, it means you have a leak. Leaks can be small at first but can quickly become big problems, causing significant water damage. If you notice any of these signs, it’s important to act fast. AllStar Plumber Tucson AZ can inspect your water heater, figure out what is wrong, and perform the necessary repairs or advise on a replacement if needed. We help keep your showers hot and your dishes clean.

A toilet that constantly runs is not only irritating but also a major water waste. The sound of water running when no one is using the toilet means water is continuously flowing from the tank into the bowl and down the drain. The most common reason for this is a faulty flapper valve. The flapper is a rubber seal at the bottom of the toilet tank that lifts when you flush and then drops back down to seal the hole. If it is old, warped, or has mineral buildup, it might not create a tight seal, allowing water to leak through. Another reason could be that the fill valve (the part that refills the tank after a flush) is set too high, causing water to overflow into the overflow tube. You can often adjust the fill valve to a lower level. Sometimes, the chain connected to the flapper is too long or too short, preventing the flapper from closing properly. You can try adjusting the chain length. If these simple fixes do not work, or if you are unsure, our skilled plumbers at AllStar Plumber Tucson AZ can quickly diagnose the issue and replace the faulty parts. We make sure your toilet is not wasting water and works efficiently.

Preventing drain clogs is much easier than fixing them. The best way to stop clogs is to be careful about what goes down your drains. In the kitchen, avoid pouring cooking grease, oil, or coffee grounds down the sink. These substances harden as they cool and stick to the inside of pipes, building up over time. Use a drain screen or stopper to catch food scraps before they go down the drain. In the bathroom, hair is the biggest culprit for clogs. Install hair catchers in your shower and bathtub drains. Avoid flushing anything other than toilet paper down the toilet. Things like wet wipes (even if they say “flushable”), paper towels, and cotton swabs can easily cause blockages. Regularly flush your drains with hot water, especially after using the sink for greasy dishes. You can also pour a mixture of baking soda and vinegar down the drain, let it sit for a while, and then flush with hot water. This can help break down minor buildup. For tough clogs or if you want a professional cleaning, AllStar Plumber Tucson AZ offers drain cleaning services that clear blockages completely and help prevent future problems. We keep your drains flowing freely.